• The PH 261-1, manual band sawing machines for cuts from 0° to 60° on the left are also supplied in a version with HB device to make single cuts without operators, still keeping the manual cutting cycle available ( the HB device is available only in the three-phase version)

    HB CUTTING CYCLE: After positioning the bar and closing the vice, the cutting phase is started, using the weight of the saw frame controlled by a hydraulic circuit to adjust the downfeed speed; after the cut the band stops, the frame is manually lifted in order to reposition the bar to cut untill the position needed by the operator , at this point the head frame is locked by the manually-controlled hydraulic valve.


    – Sturdy structures in cast iron in order to tension the band at 900 kg.

    – Electrical board with entirely identifiable wiring, stand-by, main switch with lock, short circuit protection, motor overload cutout, min. voltage coil, low voltage system 24 V.

    – Control handle IP55.

    – Driving pulley locked with clamp ring to ensure a strong fastening, still allowing axial adjustment.

    – Blade-guide heads with 6 CARBIDE pads instead of bearings to ensure a better stability.

    – Stop strokes at 0° and 60° on the left

    with lever for locking at any intermediate angle.

    – Head articulation with preloaded tapered bearings.

    – Vice with fast locking lever.

    – Electric pump for the band lubrication and cooling.

    – Brush band-cleaning device.

    – Bimetallic band for profiles and solid pieces.

    – Instructions manual and spare parts list.


MEP SpA Socio Unico - Sede: Via Enzo Magnani, 1 - 61045 Pergola (PU) - R.imprese, C.F. e P.Iva 13051480153 Cap. Sociale Eur 10.372.791,00 int. vers.