Shark 332 SXI evo, semi-automatic electro-hydraulic sawing machine , with operation also in manual and semi-automatic dynamic cycle, for cutting from 45º right to 60º left.

• Machine with controlled single axis microprocessor with the latest generation of controllers for semi-automatic sawing machines designed by MEP.

• Semi-automatic cycle: starting the cycle: – the vice closes and the motor starts – the head goes down to execute cut – motor stops – head returns to top position and vice opens.

• Semi-automatic dynamic cycle: lowering the head manually, so as to position it just above the material, the semi-automatic cycle starts by pressing trigger switch on handle.

A FEW FEATURES:

• Console with all centralized controls, installed on an articulated arm.

• Low voltage soft keyboard, in polyester, with thermo-shaped buttons, with tactile feeling and sound signal when operating.

• Display for the following messages: · Diagnostic · Allarms (cause description). · Input and output status. · Cut counting. · Time spent for the cut made. · Blade motor absorption. · Blade tension. · Blade speed. · Numeric displaying of the head position.

• Control handle of the manual cycle at 24 V, IP55.

• Program with several special cutting cycles.

• Latest generation hydraulic control unit, with high efficiency and low energy consumption.

• Rotating table (mounted on a 420 mm roller bearing, pre-loaded with thrust bearing) with steel vice plates which can be replaced after wear.- Double band rotation speed (40/80 m/min) with card PRESET to mount the electronic inverter for the continuous adjustment of the band speed (from 15 to 100 m/min).

• The limits of the head stroke are programmed through the control board, depending on the dimensions of the bars to be cut.

• Sliding vice with sideways movement and fast-positioning system which functions in automatic also when in manual mode.

• Manually-operated blade tensioning through electronic transducer, with displaying.

• Steel base allows to recover coolant also when cutting at the maximum degrees.

• Coolant tank inside the steel base with electric pump so as to lube-refrigerate band. The drawer to collect chips can be replaced with a motorized chip evacuator (see optionals).

• Preset to be equipped with the spray mist system (OPTIONAL), as well as with the standard-delivered traditional lubrication with emulsible oil.

• Wire chip brush for band cleaning.

• Machine arranged for handling with movement equipment.

• Adjustable rod to measure stop to make cuts of the same length with millimetred steel rod.

• Stock support arm with roller predisposed to mount loading table.

• Bi-metal band for solids and sections.

• Service keys and instructions manual for maintenance and spare parts list.

Documentation :